Description: This adapter can adapts any 2.5" form factor SAS/SATA/SSD Drive to 3.5" form factor drive, without cables or hassles. Standard position mounting holes on Adapter's bottom and sides, equivalent to those found on a 3.5" hard drive, give you the flexibility to mount it anywhere a 3.5" drive is used. Adapter's fixed mount connectors are attached to a simple circuit board, assuring solid connections between devices, and the outside connector is positioned to plug into a backplane as the tray is inserted. Compatible with 3Gb/s and 6Gb/s SAS/SATA/SSD drives. No loss in data transfer speeds—no bridge chip used Structure -- SECC(Steel Electrogalvanized Cold-rolled Coil) Steel body Note: This adapter can convert any 2.5" SAS/SATA/SSD drive to 3.5" form factor. However, for 2.5" SAS drives, this adapter will change dual port to single port. This is fine for most applications. But if your application requires dual port, this adapter will not work for you. And, as always, a SAS controller is required in order to support SAS drives. A 2.5" SAS drives with this adapter installed will not work on a SATA controller although its connector looks exactly the same as a normal SATA connector Note: This adapter is compatible with all the 3.5" SAS / SATA drive caddie trays from HP, Dell, IBM, or other manufacturers, such as HP 651314-001, IBM 69Y5284, or Dell F238F. Model No: ASSY 654540-001 REV B External Interface: SATA(Max. SATA3.0 6Gbps/Sec) Compatible Drive Type:2.5" SATA or SAS HDD SSD Device fit: 3.5" SATA hard hot-swappable drive bay Structure: SECC(Steel Electrogalvanized Cold-rolled Coil) Steel body Dimension:147*101*12mm Weight:100g Self collect at Tampines MRT station or Simei/Tanah Merah MRT station during office hours.
Self collect at Tampines MRT station or Simei/Tanah Merah MRT station during office hours.